MegaBreadboard 1.0

The new equipment available at ICTP SciFabLab was a great opportunity to move my project from plain copper tape and acrylic to a nice refined wooden base with engravings.

So, after installing and getting to know my way round with Inkscape, I managed to draw a very simple version of my Breadboard, with slots for the magnets and engravings with all the info on the various pins.

IMG_8152 IMG_8150

But something went wrong with my measurements and it turned out way too small… and with no intelligent way to route the wires…

IMG_8153

Back to the drawing board!